Convertible Top Moulding / Trim: Service and Repair

Removing And Installing Cover Strip

Technical values







Preliminary work

Move convertible top to service position. Refer to convertible top service position.

Removing cover strip







1. Unscrew fastening screws -1- and remove cover strip -2- from roof frame -3-.







Installing cover strip







INFORMATION: Seal for convertible-top tip must not be trapped. There must be no gap between seal and covering, and the seal with the covering must run evenly. If necessary, pull the seal up and out and tap it in again.

1. Position cover strip -2- on roof frame -3- and screw down with the fastening screws -1-. Tightening torque : 3.5 Nm (2.5 ftlb.)







Subsequent work

End service position. Refer to convertible top service position.