Installing Radiator

Installing radiator

Information

Component overview











Installing radiator

Note: The retaining clips should be mounted again immediately so that they are not confused.

Do not open the air conditioner if at all possible when removing the - radiator module. Do not bend the lines
When installing the - radiator module do not bend the lines.





1. Insert the radiator from above on the right between the ATF cooler and the air-conditioning condenser.





2. Move the ATF cooler into the installation position and push on the metal clips to fasten it.





3. Fasten servo oil cooler. To do this, push the servo oil cooler from left to right into the support -A- and clip the lines into the support -B-.





4. Tighten the fastening screw on the servo oil cooler line with a fastening screw. Tightening torque: 7.5 ft-lb.





5. Screw in both fastening screws -C- for securing condenser to the coolant radiator (left direction of travel). Tightening torque: 6 ft-lb.





6. Push on the cooler vent line onto the right radiator side and fit the spring-band clamp.





7. Push on the two coolant lines. The retaining clips on the flange must engage audibly.

Subsequent work

1. Install the radiator frame.
2. Install lock mount.
3. Fill and bleed the cooling system.
4. Fit engine guard.
5. Connect the battery.