Hazard Warning Switch: Service and Repair
Removing And Installing Hazard Warning Light Switch
Preliminary work
1. Remove PCM.
2. Remove radio.
Removing hazard warning light switch
1. Switch off ignition and remove ignition key.
2. Reach into the opening left by the removed PCM or radio, press the two retaining clips -arrows 1- together and remove the switch -arrow 2- to the front.
3. Press locking element of plug connection and remove connector.
Installing hazard warning light switch
1. Insert connector through the opening in the retaining bracket and push connector onto the hazard warning light switch until it is felt to engage.
NOTE: The retaining clips must engage.
2. Slide the switch into the retaining bracket until it clicks into place.
Subsequent work
1. Install PCM.
2. Install radio.