Removing and Installing Line For ATF Cooling 2WD
Removing and installing line for ATF coolingPreliminary work for line for ATF cooling
1. Remove engine guard.
Removing line for ATF cooling
Overview Of ATF Line:
1. Place collecting pan underneath the vehicle.
WARNING: Danger of scalding and chemical burns from hot ATF
^ Allow ATF to cool down
^ Wear personal protective gear (goggles, gloves)
2. Unscrew fastening screw -arrow- which fastens ATF line to the ATF thermostat and remove line.
3. Unscrew ATF line screw connection to engine oil pan and to transmission.
WARNING: Danger of scalding and chemical burns from hot ATF
^ Allow ATF to cool down
^ Wear personal protective gear (goggles, gloves)
4. Unscrew fastening screw securing ATF line to transmission -arrow-and remove lines.
5. Remove ATF line.
Installing line for ATF cooling
Overview Of ATF Line:
1. Install ATF line.
2. Screw in ATF line screw connection to engine oil pan Tightening torque: 7.5 ftlb. and to transmission bell housing Tightening torque: 7.5 ftlb.
3. Screw in fastening screw -arrow- which fastens ATF line to ATF thermostat. Tightening torque: 7.5 ftlb.
4. Screw in fastening screw for securing ATF line to transmission -arrow-. Tightening torque: 19 ftlb.
5. Unscrew ATF control screw -A- and fill in ATF until a constant discharge is visible at the lifting tube.
6. Screw in ATF control screw with a new sealing ring. Tightening torque: 52 ftlb.
Reworking for line for ATF cooling
1. Check and if necessary, top up the ATF.
2. Fit engine guard.