Removing and Installing Sealing Ring For Output Shaft
Removing and installing sealing ring for output shaftTools
Preliminary work for sealing ring for output shaft
1. Remove transfer box.
Removing sealing ring for output shaft
Overview of sealing ring
Screwing screws into sealing ring
1. Screw countersunk head bolt and bolt adapter from slide hammer kit NR.168 into sealing ring -direction of arrow-.
Removing sealing ring
2. Screw on slide hammer from slide hammer kit NR.168 and remove sealing ring-Bild-.
Installing sealing ring for output shaft
Overview of sealing ring
Putting on protective sleeve
1. Push special tool protective sleeve T10186-arrow- onto output shaft.
2. Push on sealing ring.
Driving in the sealing ring
3. Remove special tool protective sleeve T10186 and drive in sealing ring flush using special tool pressure piece T10180-arrow- arrow .
Subsequent work
Reworking sealing ring for output shaft
1. Install transfer box.