Removing and Installing Sealing Ring For Selector Shaft

Removing and installing sealing ring for selector shaft

Tools





Preliminary work

Preliminary work for sealing ring for right selector shaft
1. Remove multi-functional switch.

Preliminary work for sealing ring for left selector shaft
1. Remove engine guard.

Removing sealing ring for right selector shaft





1. Remove sealing ring with sharp tool, such as a scriber. -Graphic-

Removing sealing ring for left selector shaft





1. Remove retaining clip -A- on the holder.





2. Unscrew fastening nut -B- on selector shaft and remove lever.





3. Push a sharp tool, e.g. scriber, into the sealing ring and remove it. -Arrows-.

Removing sealing ring for left selector shaft





1. Remove shield on the transmission. To do this, unscrew three fastening screws -Arrow-.





2. Remove tab washer -A- on the cable.





3. Unscrew selector lever cable from the ball joint with universal disassembly tool NR.21.





4. Push a sharp tool, e.g. scriber, into the sealing ring and remove it. -Arrow-


Installing sealing ring for right selector shaft





1. Press new sealing ring with special tool pressure sleeve T10174 as far as the pressure sleeve on the transmission housing.

Installing sealing ring for left selector shaft





1. Position new sealing ring -Arrow-.





2. Press new sealing ring with special tool pressure sleeve T10174 as far as the pressure sleeve on the transmission housing.-Arrow-
3. Position selector lever on selector shaft and screw in fastening nut. Tightening torque: 11 ftlb.





4. Attach tab washer -A- to the cable holder on the transmission side.
5. Press cable on the ball joint -Arrow-.

Installing sealing ring for left selector shaft





1. Position new sealing ring -arrow-.





2. Press new sealing ring with special tool pressure sleeve T10174 as far as the pressure sleeve on the transmission housing.-arrow-
3. Position selector lever on selector shaft and screw in fastening nut. Tightening torque: 11 ftlb.





4. Attach tab washer -A- to the cable holder on the transmission side.
5. Press cable on the ball joint -arrow-.





Note:
^ When installing the shield, ensure that all fastening parts-figure are present and inserted correctly.





6. Install shield on the transmission. To do this, screw in three fastening screws -arrow-. Tightening torque: 7.5 ftlb.

Subsequent work

Reworking for sealing ring for right selector shaft
1. Install multi-functional switch.

Reworking for sealing ring for left selector shaft
1. Fit engine guard.