Removal and Replacement
Removing and installing ATF coolerPreliminary work for ATF cooler
1. Remove lock mount.
2. Remove engine guard.
Removing ATF cooler
Overview Of ATF Cooler:
1. Remove the front transverse strut under the radiator. To do this, loosen the two fastening screws (M8 x 25) to the left and right.
2. Place oil collection pan under the ATF thermostat.
WARNING: Danger of scalding and chemical burns from hot ATF
^ Allow ATF to cool down
^ Wear personal protective gear (goggles, gloves)
3. Unscrew nut on ATF line to thermostat -arrow- and drain ATF.
4. Close off line ends.
5. Remove retaining clip -arrow- on ATF cooler.
6. Remove ATF cooler.
Installing ATF cooler
WARNING: Danger of scalding and chemical burns from hot ATF
^ Allow ATF to cool down
^ Wear personal protective gear (goggles, gloves)
Overview Of ATF Cooler:
1. Position ATF cooler.
2. Install retaining clips -arrow- on ATF cooler.
3. Screw in ATF line nuts on thermostat -arrow-. Tightening torque: 22 ftlb.
4. Install the front cross member under the radiators. To do this, tighten the four fastening screws. Tightening torque: 17 ftlb.
5. Unscrew ATF control screw -A- and fill in ATF until a constant discharge is visible at the lifting tube.
6. Screw in ATF control screw with a new sealing ring. Tightening torque: 52 ftlb.
Subsequent work
Reworking ATF cooler
1. Install lock mount.
2. Check and if necessary, top up the ATF.
3. Fit engine guard.