Rear Axle/Removing and Installing Rubber Mounting For Rear Final Drive

Removing and installing rubber mounting for rear final drive

Tools








Preliminary work

Preliminary work, rubber mounting on rear final drive
1. Remove rear final drive.

Removing rubber mounting for rear final drive

Removing rubber mounting for rear final drive, drive side

Rubber Mounting, Drive Side -1-:

1. Mark rubber mounting for transmission housing at the installation position -arrow-.





2. Position special tool assembly fixture 9716 a/ b on rubber mounting.
3. Remove rubber mounting -direction of arrow-.

Removing rubber mounting for rear final drive, output side

Rubber Mounting For Output Side -2-:

1. Remove output flange with special tool striker VW 771 / 1 and material 00000-direction of arrow-.





2. Mark rubber mounting for transmission housing at the installation position -arrow-.





3. Position special tool assembly fixture 9716 a/ b on rubber mounting.
4. Remove rubber mounting -direction of arrow-.

Installing rubber mounting for rear final drive

Installing rubber mounting for rear final drive, output side

Rubber Mounting For Output Side -2-:

Note: Noises in drive line
^ Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing
^ Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing

1. Position special tool assembly fixture 9716 a/ b/ c on rubber mounting and align the markings.





2. Press rubber mounting flush.

Note: Noises in drive line
^ Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing
^ Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing

3. Install output flange.

Installing rubber mounting for rear final drive, drive side

Rubber Mounting, Drive Side -1-:

Note: Noises in drive line
^ Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing
^ Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing

1. Position special tool assembly fixture 9716 a/ b/ c on rubber mounting.

Note: Noises in drive line
^ Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing
^ Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing

2. Press rubber mounting flush -direction of arrow- into housing.

Subsequent work

Touching up, rubber mounting on rear final drive
1. Install rear final drive.