Navigation System - Enabling Extended Navigation Module

Technical Information

Cayman (987)

3/06 ENU 9110

Extended Navigation Module (off-road navigation) For PCM

Vehicle Type:
Cayman/Cayman S

Model Year:
As of 2006

Situation:
Subsequent enabling of extended navigation module for PCM

Restriction:
Only for vehicles with PCM with navigation module.

NOTE:
The extended navigation module is an optional module for the PCM2.1 and can be enabled by entering a code. When the extended navigation module is enabled successfully, an additional option "Off Road" appears in the PCM2.1 "Navi" menu. This allows automatic route recording and subsequent backtrace navigation (return journey on a previously travelled route) as well as navigation in non-digitally recorded areas using a compass and GPS.

After ordering, i.e. entering the Part No. and Vehicle Identification Number (VIN) in SAP, the enabling code should be displayed after one day once the VIN is entered in IPAS (Integrated Porsche Dealer Handling System),

Parts Info:
997.044.900.18 --> Extended navigation module for PCM

NOTE:
The function descriptions and operating instructions for the extended navigation module are included in the PCM2.1 operating instructions.

Tools:
PIWIS Tester 9718

Work Procedure:
1 Connect battery charger. --> Workshop Manual '27060150 Battery trickle charging'

2. Program extended navigation module.

2.1 PIWIS Tester 9718 must be connected and ignition switched on.

2.2 Select vehicle type.

2.3 Check that the vehicle identification number (VIN) shown in PCM and in the instrument cluster matches the VIN on the vehicle. If not, re-code the VINs in the relevant components.

2.4 Select "PCM", "PCM2 MMI", "Coding", "Off-road navi. enabling code".

NOTE: The code is entered from left to right. Missing values, up to the end of the character chain, must be entered using "zeros".

2.5 Enter the code and press -F8" to start coding.

2.6 Wait until the message "Coding was changed" appears -> coding was completed successfully.

2.7 Switch off ignition and disconnect the PIWIS Tester 9718.

3. Disconnect battery charger. --> Workshop Manual"2~/'0601'50'Battery'trickle charging'

NOTE: Further information can be found in the PCM2.1 operating instructions.

4. Carry out function test during test drive.

Working Time:
91102546:
Programming PCM display and operator control unit (extended navigation module for PCM)
Labor time: 40 TU Without:25Test drive, function test

91102544:
Programming PCM display and operator control unit (PCM2.1 navigation update)
Labor time: 70 TU

--> Workshop Manual '27060150 Battery trickle charging'
--> Technical Information '911000PCM2.1 navigation update'






Disclaimer