Hall Effect Sensor: Service and Repair

Removing And Installing Hall Sender

Preliminary work for removing hall sender
1. If the hall sender for cylinder bank 1 -3 is removed, the rear wall cover must be removed.

Removing hall sender

DANGER:
Incorrect raising of the vehicle
- Damage to person or property caused by the car falling down
- Raise the vehicle at the prescribed jacking points.

1. Release and disconnect cable plug-1-.
2. Remove hall sender -3- by unscrewing the Torx screw (M6 x 16) -2-.









Installing hall sender
1. Replace O-ring. Lightly grease O-ring -arrow- with Optimol MP3.







2. Fit hall sender -3- by screwing in and tightening the Torx screw (M6 x 16) -2-.
Tightening torque: 7.5 ftlb.
3. Push on cable plug -1-.










Subsequent work for installing hall sender
1. If the hall sender for cylinder bank 1-3 has been removed, the rear wall cover must be installed.