Removing and Installing Slide/Tilt Sunroof Trim

Removing And Installing Slide/Tilt Sunroof Trim

Preliminary work

Removing sliding-roof panel Refer to Removing and installing sliding-roof panel.

Removing slide/tilt sunroof trim







1. Position the slide/tilt sunroof trim -dimension X- approx. 80 mm in front of the roof edge cut-out.







2. Disengage left and right inner side panels. Pull out the connector springs -A- on the gate and carefully pull the slide/tilt sunroof trim upwards.







Additional instructions for removing the inner panels







INFORMATION: The inner panels must be removed or replaced if the sliding roof panel and slide/tilt sunroof trim is removed and the gate of the roof frame is extended (tilting position).

1. Push the sides of the inner panels out of the sliding roof frame inwards (centre of the vehicle).







Installing slide/tilt sunroof trim

Additional instructions for fitting the inner panels







INFORMATION: The inner panels must be removed or replaced if the sliding roof panel and slide/tilt sunroof trim is removed and the gate of the roof frame is extended (tilting position).

1. Press the sides of the inner panel into the sliding roof frame. Check function by sliding longitudinally.







Installing slide/tilt sunroof trim







1. Pull out the connector springs -A- on the gate and push in slide/tilt sunroof trim. Push inner panels under the sheetmetal panel of the slide/tilt sunroof trim.







2. Position the slide/tilt sunroof trim -dimension X- approx. 80 mm in front of the roof edge cut-out.







3. Engage the left and right-hand inner side panels in the slide/tilt sunroof trim.







Subsequent work

Install sliding-roof panel. Refer to Removing and installing sliding-roof panel.