Removing and Installing Torque Converter Sealing Ring

Removing and installing torque converter sealing ring





Information

Notes

Information
When pulling out, the torque converter must be kept horizontal, otherwise ATF can emerge.

Information
Before installing the torque converter, check the hub for scoring. If damaged, the converter must be replaced.

Preliminary work

1. Remove transmission.
2. Put transmission in horizontal position.

Removing torque converter

1. Locating pin 95951 (long) must be removed from transmission housing.





Fixing the torque converter

Information
When pulling out, the torque converter must be kept horizontal, otherwise ATF can emerge.

2. Screw two screws (M8) into torque converter and remove torque converter using the screws from transmission input shaft.





Pulling out torque converter

Removing torque converter sealing ring

1. Remove sealing ring for torque converter with hook VW 681.





Removing sealing ring

Installing torque-converter sealing ring

1. Thinly coat sealing lip of new sealing ring with Vaseline.
2. Drive in sealing ring with pressure piece 96700 as far as the mounting face.





Fitting sealing ring

Subsequent work

Installing torque converter

Information
Before installing the torque converter, check the hub for scoring. If damaged, the converter must be replaced.

1. Move torque converter up to stop on the transmission input shaft.

Caution
Torque converter installed at the wrong position during fitting
^ Risk of damage to ATF pump

-> Check that the torque converter is installed at the correct position.

-> Check installation position of torque converter.

2. Press torque converter by hand into the converter bell housing and turn until the cut-out of the converter hub clicks into place in the driver of the impeller. The converter must slip inwards until it makes a noise.

Information
If the locating pins 95951 (long) cannot be inserted as shown, check the torque converter again to ensure that the installation position is correct.

3. Secure torque converter in installation position with locating pin 95951 (long).





Fixing the torque converter

Subsequent work

1. Mount transmission.
2. After reinstalling the engine-transmission unit, the ATF level must be checked, and topped up as required.