37311900 Removing and installing multi-functional switch
WM 373119 Removing and installing multi-functional switch
Tools
Technical values
Preliminary work
1. Remove engine-compartment lid. -> 557819 Removing and installing engine compartment lid - section on "Removing"
2. Fix the engine in the installation position using safety device 10-222 A at the engine lifting bracket.
Safety device
3. Raise the vehicle at the prescribed jacking points. -> 400000 Lifting the vehicle
4. Remove support plate. -> 421419 Removing and installing support plate - section on "Removing" 42141900 Removing and installing support plate
Removing multi-functional switch
DANGER
If the supports are folded down, the vehicle will roll off the platform lift when it is lowered.
-> Ensure that the platform is prevented from lowering.
-> Remove supports before lowering.
1. Lever selector cable off the ball pin and disengage from support bracket.
Selector cable
2. Place transmission jack under the transmission.
3. Unscrew fastening screws between the transmission and the transmission support.
Transmission jack screws
Information
The fastening nuts of the transmission support must never be loosened at the hydraulic mount because otherwise the transmission brackets will be damaged.
4. Unscrew fastening screws between the body and the hydraulic mount -arrows-.
Transmission support
5. Disconnect the plug connection for the multi-function switch.
Connector
6. Unscrew fastening screws between multi-functional switch and transmission and pull off multi-functional switch from selector lever.
Fastening screws of multi-functional switch
Installing multi-functional switch
Information
- When connecting the multi-functional switch to the selector lever, the multi-functional switch must not be tilted or pushed with force onto the selector lever. Otherwise there is a risk of damaging the switch contact.
1. Connect multi-functional switch to the selector shaft. The flattened area of the switch splines -1- must be covered with the flattened side of the selector shaft splines. -2-.
Connecting multi-functional switch
2. Connect multi-functional switch to transmission housing. To do this, turn the multi-functional switch until the dowel pin -3- on the transmission housing is covered by the fitted bore -4- on the housing of the multi-functional switch.
Aligning multi-functional switch
3. Screw in fastening screws between multi-functional switch and transmission.
Fastening screws of multi-functional switch
4. Connect the plug connection for the multi-function switch.
Connector
5. Screw in fastening screws between the body and the hydraulic mount -arrows-.
Transmission support
6. Screw in fastening screws between the transmission and the transmission support.
Transmission jack screws
7. Remove transmission jack.
8. Engage selector cable in support bracket and push onto ball journals.
Selector cable
Subsequent work
1. Install support plate. -> 421419 Removing and installing support plate - section on "installing" 42141900 Removing and installing support plate
2. Lower the vehicle.
3. Remove safety device 10-222 A.
Safety device
4. Install the engine-compartment lid. -> 557819 Removing and installing engine compartment lid - section on "Installing"