Removing and Installing Hardtop Fastening

611719 Removing And Installing Hardtop Fastening






Preliminary work
Remove cover for the rear.

Removing hardtop fastening

Removing bracket for hardtop mount






NOTE: Only when removing the left bracket for hardtop mount.

1. Press in locking tabs -Arrows A- and pull electric plug connection -1- up and off -Arrow B-.






2. Unscrew fastening screws -2- inside and remove the retaining angle -3-.
3. Unscrew fastening screws -2- outside and remove bracket for hardtop mount -4- upwards out of the frame of roll-over protection system -5-.

Installing hardtop fastening

Installing bracket for hardtop mount






1. Position bracket for hardtop mount -4- on frame for roll-over protection system -5- and screw down the fastening screws -2- on the outside. Tightening torque Tightening torque: 9.7 Nm (7.2 ftlb.)






2. Position retaining angle -3- on frame for roll-over protection system -5- and screw down with the fastening screws -2- on the inside. Tightening torque Tightening torque: 9.7 Nm (7.2 ftlb.)

NOTE: Only when removing the left bracket for hardtop mount.

3. Press in electric plug connection -1- until it audibly engages.

Subsequent work
Install cover for rear.