Removing and Installing Microswitch For Roof

Removing And Installing Microswitch For Roof

Preliminary work

1. Open convertible top.
2. Remove interior light. Refer to Replacing bulb for interior light.
3. Remove operator control unit for garage door opener. Refer to Removing and installing operator control unit for garage door opener.
4. Remove front lock. Refer to Removing and installing front lock.

Removing microswitch for roof







1. Loosen circlips -1- (by turning them -Arrow a- with a small screwdriver) -2- from the front lock -4- and lift them up and off -Arrow A-.







2. Remove microswitch for roof -3- from front lock -4- by pulling it upwards -Arrow B-.

Installing microswitch for roof

1. Insert microswitch for roof -1- from above -Arrow A- into the front lock -2-.







INFORMATION: New circlips must always be used when securing the microswitch.

2. Fit circlips -3- from above -Arrow B- and press in until they connect fully with the roof microswitch -1-.

Subsequent work

1. Install front lock. Refer to Removing and installing front lock.
2. Install operator control unit for garage door opener. Refer to Removing and installing operator control unit for garage door opener.
3. Install interior light. Refer to Replace bulb for interior light.
4. Close convertible top.