Body/Accessories - Aerokit(R) Retrofitting
11/07 ENU 6658Aerokit (I-no. XAF)
10/22/07
Vehicle Type:
911 Turbo (997)
Model Year:
As of 2007
Situation:
Retrofitting
Concerns:
Coupe only
Information:
The Aerokit comprises the following components:
^ Modified ready printed front spoiler
^ Two ready-printed sill covers
^ Ready-primed rear panel
^ New rear lid with fixed spoiler and spoiler lip.
The components have been tested arid approved together. Individual parts cannot he fitted. All ready-pruned parts can be painted according to the vehicle's color code.
The Aerokit is also available as an factory installed option for new vehicles by requesting optional equipment "XAF".
The model logo, which must be ordered separately as a spare part, can be fitted at the same position on the rear lid at the request of the customer.
Parts Info:
997.044.802.06 --> Aerokit -ready-primed-, complete
Parts List:
Spare Parts:
Materials:
Tools:
ATTENTION
Different approach angle compared to standard vehicle
^ Risk of damage to components
--> Avoid steep ascents, descents or ramps wherever possible.
--> Always drive according to the prevailing driving conditions.
ATTENTION
Incorrect and improper use of new accessories
^ Risk of damage to components or to the vehicle
--> Never use the spoiler to push the vehicle.
--> Do not use force when opening and closing the rear lid.
--> Observe specified gap dimensions for new accessories with respect to adjacent components and fit new accessories accordingly.
ATTENTION
Cleaning the vehicle
Risk of damage to the vehicle, paintwork and components
--> When washing the vehicle in an automatic car wash, check that the spoiler is detected by the light barriers.
--> If in doubt, seek the advice of the operator of the automatic car wash.
--> Only use cleaning agents as listed in the owner's manual.
ATTENTION
Affixing components using adhesive tape
^ Risk of damage to the vehicle or paintwork
^ Risk of damage to components
--> Clean bonding surfaces to remove any dust and grease.
--> Use clean, lint-free disposable cloths for cleaning.
--> Do not touch the bonding surfaces with your fingers.
--> The object (component, vehicle) and ambient temperature must be at least 59° F (15° C). Press component on with a suitable tool (rubber roller) using the prescribed pressure.
Note
Please pass this information or to the customer as well.
Work Procedure:
Working Times:
Disclaimer