9662AN00 Teaching Remote Control

WM 9662AN Teaching remote control

Tools






Procedure for teaching remote controls

Information

- The immobiliser system consists of four components - Kessy control unit/immobiliser control unit, electrical steering lock, DME control unit and vehicle remote control.

- If one of these components needs to be replaced because of a defect, the new component can be taught to suit the existing system. To do this, the PIWIS Tester 9718 and the immobiliser code from the PIWIS Infosystem are required.

- You can get the codes from the PIWIS Infosystem or from your importer by specifying the vehicle identification number.

- Follow the instructions for the Porsche System Tester.

Information

- Only new hand-held transmitters or those already adapted to the immobiliser system on the vehicle can be taught.

- Hand-held transmitters that are already adapted are overwritten, and so all hand-held transmitters that will later be used on the vehicle must be taught.

- Teaching of keys is protected over a time period. Once this time has elapsed, teaching is aborted.

1. Ignition off. Connect the Porsche System Tester to the vehicle and start the System Tester. Select vehicle type.
2. Switch on hazard warning light; this will activate CAN and ensure that the KESSY control unit is identified.
3. Select Kessy control unit and press >>.
4. Select Teaching function menu and press >>.
5. Select Teach keys menu and press >>.
6. Enter immobiliser code and press >>. Then confirm your entry by pressing F7.
7. Insert key 1.
8. Enter the number of keys (1-8) to be taught and press >>. Then confirm your entry by pressing F7.

Turn key No. 1 (already inserted in ignition lock) to position ON (ignition) - ignition is switched on if teaching is correct.

Information

- In the case of keys with the Keyless function, after teaching, press a button on the radio remote control to activate this function.

Turn key No. 1 to OFF and remove from ignition lock.

Insert key No. 2 in ignition lock and turn to position ON (ignition), then press >> - ignition is switched on if teaching is correct.

Repeat procedure with all keys to be taught (having entered number).
9. Read out and erase fault memory.
10. Start the engine using each of the keys/remote controls that were taught one after the other.