708719 Removing and Installing Lining For Rear Lid
WM 708719 Removing and installing lining for rear lid
Removing lining for rear lid
Removing cover for window frame
Information
- To reduce the unclipping forces and thereby the risk of damage during removal, the removal steps must be carried out at the accessible connection points using a suitable tool.
1. Open rear window.
2. Open rear lid.
3. Unclip centre window frame trim -2- from the rear lid and from the side window frame trim -3- at the marked positions. To do so, raise the trim slightly and lever out the clip connection -5- using a screwdriver.
4. Move the rear lid to the intermediate position shown => see figure.
5. Unclip side window frame trim -3- from the rear lid and from the rear lid trim at the marked positions -1-. To do so, raise the trim slightly and lever out the clip connection using a screwdriver.
6. Close rear lid. The rear window -12- remains open.
7. Unclip top window frame trim -4- at the places indicated ( -circle marks- ) from the rear lid. To do so, raise the trim slightly and lever out the clip connection using a screwdriver.
Removing lining for lid
1. Unclip cover for rear wiper motor -11- at the marked positions. To do so, raise the trim slightly and lever out the clip connection using a plastic wedge.
2. Open the rear lid.
3. Unclip side lights -6, 7-.
4. Disengage plug connection -arrows-.
5. Remove position lights -6, 7- -arrow-.
6. Lever the lock cover -8- out of the rear lid lining -1- using a screwdriver.
7. Unscrew fastening screw -10-.
8. Remove finger plate -9- from the rear lid lining -1-.
9. Unclip the rear lid lining -1- from the rear lid at the marked positions. To do so, raise the trim slightly and lever out the clip connection using a screwdriver.
Installing lining for rear lid
Installing lining for lid
1. Check clips for deformation; replace if necessary.
2. Clip the rear lid lining -1- onto the rear lid at the marked positions.
3. Insert handle liner -9- into the rear lid lining -1-.
4. Screw in fastening screw -10-.
5. Clip lock cover -8- into the rear lid lining -1-.
6. Engage plug connection on the side lights -arrow-.
7. Insert side lights -6, 7- into the rear lid lining and clip into place.
8. Check sheetmetal retaining clips => see figure for deformation; replace if necessary.
9. Clip cover for rear wiper motor -11- onto the rear lid at the marked positions.
Installing the window frame trim
1. Close rear lid. Open rear window -12-.
2. Check sheetmetal retaining clips -5- and clips for deformation; replace if necessary.
3. Clip top window frame trim -4- at the places indicated ( -circle marks- ) on the rear lid.
4. Move the rear lid to the intermediate position shown => see figure.
5. Clip the side window frame trim -3- onto the rear lid and the rear lid lining at the marked positions.
6. Clip centre window frame trim -2- onto the rear lid at the marked positions.
7. Close rear lid and rear window.