576319 Removing and Installing Rubber Seal for Front Door
WM 576319 Removing and installing rubber seal for front door
Removing the rubber seal for front door
1. Open front door.
2. Remove A-pillar trim. -> 705719 Removing and installing A-pillar trim - section on "Removing" 705719 Removing and installing A-pillar trim
3. Remove front grab handles. -> 683519 Removing and installing grab handle - section on "Removing" 683519 Removing and installing front handle
4. Remove front side section trim. -> 702419 Removing and installing front side section trim - section on "Removing" 702419 Removing and installing front side section trim
5. Removing seal.
Information
The roof cover must be carefully pulled down slightly in the upper area. Make sure that the roof cover does not buckle.
5.1. Remove seal -1- all round sheetmetal flange -arrows-.
Installing the rubber seal for front door
Information
The roof cover must be carefully pulled down slightly in the upper area. Make sure that the roof cover does not buckle.
1. Install new seal.
1.1. Position new seal for front door -1- with connection point -2- in the area indicated (on A-pillar structure) -Arrow A- of the sheetmetal flange -3-. The seal air vents must face towards the outside of the vehicle.
1.2. Press new seal -1- onto sheetmetal flange.
2. Check whether the installation is correct.
2.1. Pay particular attention to the areas near the tight roundings for correct installation; there must be no deformation or stretching.
2.2. Check the air vents; they must not be closed or covered.
3. Install front side section trim. -> 702419 Removing and installing front side section trim - section on "Installing" 702419 Removing and installing front side section trim
4. Install front grab handles. -> 683519 Removing and installing grab handle - section on "Installing" 683519 Removing and installing front handle
5. Install A-pillar trim. -> 705719 Removing and installing A-pillar trim - section on "Installing" 705719 Removing and installing A-pillar trim
6. Closing front door