586419 Removing and Installing Outside Rubber Seal for Rear Door

WM 586419 Removing and installing outside rubber seal for rear door

Removing outside rubber seal for rear door

Removing front rubber seal

1. Open rear door

2. Remove cover of front assembly opening
2.1. Unclip cover of front assembly opening -1- and remove it ( -Arrow A- ).

3. Remove front rubber seal
3.1. Pull out retaining lug at top of rubber seal -2- from fixing device on door inner panel -3- ( -Arrow B- ).

3.2. Remove rubber seal -4- , starting at top of door flange -5- ( -Arrows C- ).

Removing rear rubber seal

1. Remove rear wheel housing liner
1.1. => Removing rear wheel housing liner

2. Remove rear rubber seal
2.1. Pull out top of rubber seal -6- from C-pillar panel -7- ( -Arrow D- ).

2.2. Release clip fastenings of rubber seal -6- , starting at the top using a plastic wedge -12- ( -Arrows E- ).

2.3. Remove rubber seal -6- , starting from the top at the flange of the wheel opening -8- ( -Arrows F- ).

Installing outside rubber seal for rear door

Installing front rubber seal

1. Install front rubber seal
1.1. Insert rubber seal -4- into the seal of the door panel -9- ( -arrow A- ) and fit it to the door flange -5- , starting at the bottom ( -arrow B- ).

1.2. Insert the seal end piece at the top -10- behind the door unit carrier -11- ( -arrow C- ).

1.3. Press retaining lug at top of rubber seal -2- into the fixing device on the inner door panel -3- ( -arrow D- ).

2. Clipping in cover of front assembly opening
2.1. Clip in cover of front assembly opening -1- ( -Arrow E- ).

Installing rear rubber seal

1. Install rear rubber seal
1.1. Push rubber seal -6- - starting at the middle -arrow F- - onto flange of wheel opening -8- ( -arrow G- ).

1.2. Press in clip fastenings of rubber seal -6- ( -arrow H- ).

1.3. Insert top end piece -12- of rubber seal -6- behind the C-pillar panel -7- ( -arrow I- ).

2. Installing rear wheel housing liner
2.1. => Installing rear wheel housing liner
3. Close rear door