Operation CHARM: Car repair manuals for everyone.

Removing And Installing Pressure Line In Vehicle



Removing And Installing Pressure Line In Vehicle

Technical values







Preliminary work
1. Remove rear side trim panel.
2. Unscrew auxiliary air-conditioning unit.

Removing pressure line in vehicle

CAUTION:
Danger of injury from contact with the refrigerant.
- Observe safety regulations when working with refrigerant.








1. Remove refrigerant by suction







2. Raise the auxiliary air-conditioning unit and unscrew both fastening screws -1-.
3. Remove the pressure line -Arrows- and seal with plugs.

Installing pressure line in vehicle







1. Remove the plugs on the pressure line, check the O-rings and replace if in doubt.
2. Raise the auxiliary air-conditioning unit and push the pressure line onto the connections -arrow- and screw down with both fastening screws -1-. - Tightening torque: 12 Nm (9.0 ftlb.).







3. Ensure that the water drain is connected to the drain when fitting the auxiliary air-conditioning unit.

Subsequent work
1. Fill in refrigerant.
2. Screw down auxiliary air-conditioning unit.
3. Install rear side trim panel.