Removing And Installing Suction Line In Vehicle

Removing And Installing Suction Line In Vehicle

Technical values







Preliminary work
1. Remove rear side trim panel.
2. Unscrew auxiliary air-conditioning unit.

Removing suction line in vehicle

CAUTION:
Danger of injury from contact with the refrigerant
- Observe safety regulations when working with refrigerant.







1. Remove refrigerant by suction.







2. Raise the auxiliary air-conditioning unit and unscrew both fastening screws -1-.
3. Remove the suction line -Arrows- and close with plugs.

Installing suction line in vehicle
1. Remove the plugs on the suction line, check the O-rings and replace if in doubt.







2. Raise the auxiliary air-conditioning unit and push the suction line onto the connections -arrows- and screw down with both fastening screws -1-. - Tightening torque: 12 Nm (9.0 ftlb.)







3. Ensure that the water drain is connected to the drain when fitting the auxiliary air-conditioning unit.

Subsequent work
1. Fill in refrigerant.
2. Screw down auxiliary air-conditioning unit
3. Install rear side trim panel.