373119 Removing and Installing Multi-Functional Switch

WM 373119 Removing and installing multi-functional switch

Technical values





Preliminary work

Preliminary work for multi-functional switch

1. Remove engine guard. -> 108019 Removing and installing engine guard - section on "Removing" 108019 Removing and installing engine guard (underbody panelling)

Removing multi-functional switch





Overview of multi-functional switch

1. Move selector lever to position N.
2. Remove shield on the transmission. To do this, unscrew three fastening screws -Arrow-.





Shield to right side of transmission

3. Pull off cable on multi-functional switch.
4. Remove cap nut, cap, nut with tab washer and rubber washer on the multi-functional switch.





Assembling multi-functional switch

5. Unscrew fastening screws on the multi-functional switch -Arrow- and remove switch.





Fastening screws for multi-functional switch

Installing multi-functional switch





Overview of multi-functional switch

1. Put multi-functional switch on the selector shaft.
2. Adjust multi-functional switch. -> 373115 Adjusting multi-functional switch 373115 Adjusting multi-functional switch
3. Position cable on multi-functional switch.
4. Install shield on the transmission. To do this, screw in three fastening screws -Arrow-. => Tightening torque: 10 Nm (7.5 ftlb.)





Shield to right side of transmission

5. Functional test of gear selecting system:
- Will the vehicle start?
- Do all the selector lever positions work?

Subsequent work

Subsequent work for multi-functional switch

1. Install engine guard. -> 108019 Removing and installing engine guard - section on "Installing" 108019 Removing and installing engine guard (underbody panelling)