Part 2

WM 1001IN Tightening torques, tightening sequences, assembly overviews for V8 4.8 l DFI naturally aspirated and turbo engine up to October 2008

Studs for cylinders 1 to 4, catches

Studs for cylinders 5 to 8, catches

Valve cover seals, cylinders 1 to 4

Valve cover seals, cylinders 5 to 8

Tightening sequence for valve cover for cylinders 1 to 4

Tightening sequence for valve cover for cylinders 5 to 8

Bar ignition modules and valve cover, cylinder bank 1 to 4

Bar ignition modules and valve cover, cylinder bank 5 to 8

Camshafts, cylinder bank 1 to 4

Camshaft mount, cylinder bank 1 to 4

Camshafts, cylinders 5 to 8

Camshaft mount, cylinders 5 to 8

Camshaft control

Camshaft identification on V8 turbo engine M48/51

Camshaft identification on V8 naturally aspirated engine M48/01

Camshaft bearing cover identification

Timing chain and sprockets

Oil pump chain drive

Timing chain and chain guide

Timing-case cover seals

Applying sealing compound (fill openings in sheetmetal seal with sealing compound)

Tightening sequence for timing-case cover

Chain tensioner, sealing flange

Group 17 up to October 2008

Oil/coolant heat exchanger, oil filter

Applying sealant to oil guide housing

Oil guide housing with accessories

Oil pressure sensor and oil pressure measuring point

Oil level measurement

Oil lines on turbo engine (M48/51)

Oil lines on naturally aspirated engine (M48/01)

Oil lines, intake manifold on turbo engine M48/51

Oil lines, intake manifold on naturally aspirated engine M48/01