Removing And Installing Front Wire Harness

Removing And Installing Front Wire Harness

Preliminary Work
1. Remove front apron.

Removing Front Wire Harness







1. Unclip plug connections on the front apron at the right.
1.1. Unclip plug connections -1 and 2- on the front apron -arrows A-.







1.2. Unclip front wire harness -4- at the line bracket -3- ( -arrow B- ).







2. Release connector -1- ( -arrow A- ) and pull it off the fog light -2- at the left and right -arrow B-.
3. Disconnect plug connections for front direction indicator at the left and right.
3.1. Release connectors for direction indicator light and parking light -1 and 2- ( -arrows A- ) and pull them off the front direction indicator -3- ( -arrows B- ).







3.2. Unclip wire harness -4- ( -arrow C- ).







4. Take front wire harness -1- out of the air grille holders at the left and right -arrows-.







5. Unclip front wire harness -1- at the left and right -arrows- and cut tie-wraps -2-.







6. Unclip front wire harness -1- in the middle -arrows- and cut tie-wraps -2-.
7. Pull off connector on sensors for ParkAssist.
7.1. Release clips -arrows A- and remove sensor for ParkAssist -1- ( -arrow B- ).







7.2. Release connector -2- ( -arrow C- ) and pull it off the sensor for ParkAssist -1- ( -arrow D- ).

8. Remove front wire harness.

Installing Front Wire Harness
1. Plug in connector on sensor for ParkAssist.
1.1. Plug in connector -2- on sensor for ParkAssist -1- ( -arrow A- ) until the connector -2- engages securely.







1.2. Press sensor for ParkAssist -1- into the mounting -arrow B- until the clips engage securely.







2. Clip in front wire harness -1- in the middle -arrows- and secure with new tie-wraps -2-.







3. Clip in front wire harness -1- at the left and right -arrows- and secure with new tie-wraps -2-.







4. Insert front wire harness -1- into the air grille holders at the left and right -arrows-.
5. Connect plug connections for front direction indicator at the left and right.
5.1. Clip in wire harness -4- ( -arrow A- ).







5.2. Connect connectors for the direction indicator light and parking light -1 and 2- to the front direction indicator -3- ( -arrows B- ) until the connectors engage securely.







6. Push connector -1- onto the fog light -2- at the left and right -arrow- until the connector engages securely.
7. Clip front wire harness into the front apron at the right.
7.1. Clip front wire harness -4- and line bracket -3- into the front apron -arrow A-.







7.2. Clip plug connections -1 and 2- into the front apron -arrows B-.


Subsequent Work
1. Install front apron.