Removing And Installing Front Wiring Harness
Removing And Installing Front Wiring Harness
Preliminary work
Removing front apron.
Removing Front Wiring Harness
Disconnecting Plug Connection For Main Wiring Harness:
1. Switch off ignition and remove ignition key.
2. Release plug connection for main wiring harness (front left cross member) -arrow a- and disconnect.
Disconnecting The Outside Temperature Sensor
1. Push outside temperature sensor out of the lock support.
2. Release plug connection for outside temperature sensor -arrow A- and disconnect -arrow B-.
Removing Front Wiring Harness
1. Release the connectors to the horn to the left and right -arrow a- and remove them -arrow B-.
2. Cut tie-wrap -2-.
3. Unclip front wiring harness -1- from its retaining clips -arrow C- and push out of the retaining clamp and the lock mount -arrows D and E-.
4. Unclip plug connection for lid lock from the lock support -arrow A- , release -arrow B- and remove it -arrow C-.
5. Unclip wiring harness from the lock support -arrows D-.
6. Open the four retaining clips -arrow A- and pull out the wiring harness -arrow B-.
Installing Front Wiring Harness
1. Run the wiring harness through the four retaining clips -arrow A- and close the clips -arrow B-.
2. Clip wiring harness to the lock support -arrows A-.
3. Push the plug connection for the lid lock together -arrows B- until it is felt to engage. Clip lid lock plug connection to the lock support -arrow C-.
4. Press the front wiring harness -1- into the retaining clamp and the lock support -arrows A and B- and clip it into the retaining clips -arrow C-.
5. Secure the front wiring harness -1- to the lock support with a new cable tie -2-.
6. Plug in the left and right connectors for the horn -arrow D- until they are felt to engage.
Locking Outside Temperature Sensor Connector
1. Plug in the outside temperature sensor connector -arrow A- until the locking tab -B- is felt to engage.
2. Push the outside temperature sensor into the lock support -arrow A- until the locking tabs -B- are felt to engage.
Locking Plug Connection For Main Wiring Harness
1. Join the plug connection for the main wiring harness together (front left cross member) until it is felt to engage.
Subsequent Work
Installing front apron.