Body - Sport Design Package Retrofitting
16/7 ENU 6658SportDesign Package (I-no. 2D1/2D2/2D3)
Aug 23, 2007
Vehicle Type:
Cayenne/Cayenne S/Cayenne Turbo
Model Year:
As of 2008
Information:
Retrofitting
Notes:
The SportDesign package further emphasizes the sporty nature of the Cayenne. This package is available as follows:
^ SportDesign package, complete (I-no. 2D1); comprising one lower part for the front and rear apron, one rear spoiler and both side skirts (all ready-primed)
^ SportDesign package without side skirts (I-no. 2D2) for vehicles with a running board and/or rock rails
^ Side skirts (I-no. 2D3), complete incl. mounting parts
Other combinations have not been tested and are therefore neither approved nor permitted!
If mud flaps are fitted on the vehicle, these must be removed from the lower part of the rear apron and refitted on the new lower part.
Furthermore, if a wheel arch extension is fitted, the short type must be replaced with the long type.
Parts Info:
These parts must be ordered separately, depending on the vehicle equipment.
Parts List:
Materials:
Tools:
ATTENTION
Reduce ground clearance in the sill area compared to standard vehicles
^ Risk of damage to components
--> Always drive according to the prevailing driving conditions.
--> Avoid steep access and exit ramps wherever possible.
ATTENTION
Incorrect and improper use of new accessories
Risk of damage to components or to the vehicle
--> Never use the spoiler to push the vehicle.
--> Do not use force when opening and closing the rear lid.
--> Observe specified gap dimensions for new accessories with respect to adjacent components and fit new accessories accordingly.
ATTENTION
Cleaning the vehicle
^ Risk of damage to the vehicle, paintwork and components
--> When washing the vehicle in an automatic car wash, check that the spoiler is detected by the light barriers.
--> If in doubt, seek the advice of the operator of the automatic car wash.
--> Only use cleaning agents listed in the car manual.
ATTENTION
Lifting the vehicle
^ Risk of damage to the vehicle, paintwork and components
--> Remove cover or trim at the jacking point.
--> Position car jack only at the jacking points provided.
--> Observe notes provided in Owner's Manual.
Note
Please pass this information on to the customer as well.
Work Procedure
Working Time
Disclaimer