387019 Removing and Installing Sealing Ring For Output Shaft

WM 387019 Removing and installing sealing ring for output shaft

Tools






Preliminary work

Preliminary work for sealing ring for output shaft

1. Remove transfer box. -> 396519 Removing and installing transfer box - section on "Removing" Service and Repair

Removing sealing ring for output shaft





Overview of sealing ring

1. Screw countersunk head bolt and bolt adapter from slide hammer kit NR.168 into sealing ring -direction of arrow-.





Screwing screws into sealing ring

2. Screw on slide hammer from slide hammer kit NR.168 and remove sealing ring -Image-.





Removing sealing ring

Installing sealing ring for output shaft





Overview of sealing ring

1. Push special tool protective sleeve T10186 -arrow- onto output shaft.





Putting on protective sleeve

2. Push on sealing ring.
3. Remove special tool protective sleeve T10186 and drive in sealing ring flush using special tool pressure piece T10180 -arrow- arrow.





Driving in the sealing ring

Subsequent work

Reworking sealing ring for output shaft

1. Install transfer box. -> 396519 Removing and installing transfer box - section on "Installing" Service and Repair
2. Check ATF. -> 370235 Checking and topping up ATF 370235 Checking and topping up ATF