371237 Disassembling and Assembling Cover For Selector Lever

WM 371237 Disassembling and assembling cover for selector lever

Tools






Preliminary work for cover for selector lever

1. Remove selector knob. -> 370419 Removing and installing selector knob - section on "Removing" 370419 Removing and installing selector knob
2. Remove cover of centre console. To do this, unscrew two screws -arrows on right- , separate plug connection -inset- , tip cover up -curved arrow- and back, and remove.





Removing centre console cover

3. Remove selector lever cover with special tool unlocking hook 9713. To do this hook into the left and right of the unlocking bracket -inset- from the front and press outwards. Pull the cover upwards slightly at the same time.





Releasing the selector lever cover

4. Release the rear release plates in the same way.
5. Remove selector-lever cover and separate cable connection.





Cable plug for selector lever cover

Disassembling cover for selector lever





Overview of cover for selector lever

Information

- Use a clean and soft working surface to disassemble the cover for the selector lever.

Information

- Only press the retaining lugs until the shade loosens from the upper part.

- Otherwise, the retaining lugs can break.

1. Release the lugs -arrows- on one side on the underside of the cover for the selector lever.





Releasing the shade

2. Tip shade up on this side => Removing the shade and remove.





Removing the shade

Assembling cover for selector lever

Information

- Use a clean and soft working surface to disassemble the cover for the selector lever.

1. Before assembly, the printed circuit board is to be inserted correctly -arrows-.





Fastening the printed circuit board

2. The shade must be inserted in the correct position, sliding contact -1- on grinding track -2-.





Position of upper part to lower part

3. Fasten shade on the one side with the retaining lugs -arrows-.





Inserting the shade

4. Push shade onto the upper part => Fastening the shade , until it locks with an audible click.





Fastening the shade

Subsequent work

Subsequent work for cover of selector lever

1. Connect cable connection on underside of selector lever cover.
2. Install selector lever cover. Make sure that the wiring harness -arrows- is not pinched in the selector frame.





Cable lead to selector frame

3. Position cable connection -inset- on the underside of the centre console cover.





Fitting centre console cover

4. Insert centre console cover at the front and tip backwards -curved arrow-. Screw in two screws -arrows on right-.





Fitting centre console cover

5. Install selector knob. -> 370419 Removing and installing selector knob - section on "Installing" 370419 Removing and installing selector knob