370819 Removing and installing selector support
WM 370819 Removing and installing selector support
Tools
Technical values
Preliminary work
Preliminary work for selector frame
1. Remove selector knob. -> 370419 Removing and installing selector knob - removing 370419 Removing and installing selector knob
Removing selector support
Removing selector frame
Overview of selector frame
1. Remove cover of centre console. To do this unscrew two screws -right arrows- , separate plug connection -inset- , tip cover up -curved arrow- and back and remove.
Removing centre console cover
2. Remove selector lever cover with special tool unlocking hook 9713. To do this hook into the left and right of the unlocking bracket -inset- from the front and press outwards. Pull the cover upwards slightly at the same time.
Releasing the selector lever cover
3. Unlock the rear unlocking brackets in the same way.
4. Remove selector lever cover and separate cable connection.
Cable plug for selector lever cover
5. Pull off electrical plug connections.
Cable plug for selector frame
6. Remove the transverse strut of the centre console.
Transverse strut of selector frame
7. Unscrew selector frame screws -arrows-.
Screw connection of selector frame
8. Unscrew cable fastening screw -right arrow- on the cable adjustment using special tool special inserts model AB NR.170 and remove retaining clip -left arrow-.
Selector lever cable connection
9. Remove selector frame.
Installing selector support
Removing and installing cable adjustment
Information
- When a new selector support is used, the cable adjustment of the selector cable must be modified.
1. Remove pins -direction of arrow- and take out cable adjustment.
Removing the cable adjustment
2. Insert cable adjustment on the new selector support and install pins -direction of arrow-.
Installing the cable adjustment
3. When doing so, ensure that the opening for the adjusting screw -arrow- is turned upwards.
Cable adjustment
Installing selector frame
Overview of selector frame
1. Push selector lever cable into cable adjustment.
2. Push on retaining clip -left arrow- and screw in fastening screw -right arrow- using the special inserts model AB NR.170 tool and the accessory for the torque wrench: open ring wrench insert a/f 13 + adapter NR.98-1 on the cable adjustment. => Tightening torque: 7.5 ftlb.
Selector lever cable connection
3. Adjust selector lever cable. -> 371515 Adjusting selector lever cable 371515 Adjusting selector lever cable
4. Position selector frame and screw in screws -arrows-. => Tightening torque: 4.5 ftlb.
Selector frame to body
5. Install the transverse strut of the centre console.
Transverse strut of selector frame
6. Position electric plug connections -arrow- on the selector frame.
Cable plug for selector frame
7. Position cable connection on the underside of the selector lever cover.
8. Install selector lever cover. Make sure that the wiring harness -arrows- is not pinched in the selector frame.
Cable lead to selector frame
9. Position cable connection -inset- on the underside of the centre console cover.
Fitting centre console cover
10. Insert centre console cover at the front and tip backwards -curved arrow-. Screw in two screws -right arrows-.
Fitting centre console cover
Subsequent work
Reworking selector frame
1. Install selector knob. -> 370419 Removing and installing selector knob - installing 370419 Removing and installing selector knob