92411900 Removing and installing wiper arm for rear window wiper system

WM 924119 Removing and installing wiper arm for rear window wiper system

Tools





Technical values






Removing wiper arm for rear window wiper system

1. Switch on ignition, turn on wiper for rear window wiper system and as soon as the wiper is positioned vertically, switch off ignition. The wiper must remain in a vertical position.





Position of rear window wiper for removal

CAUTION

Danger of crushing and trapping when working on the rear window wiper system.

-> Before removing wiper arm, remove ignition key and switch off steering column switch.

2. Unclip cap -1- at the sides and remove it.





Screwing off fastening nut for rear window wiper

3. Loosen fastening nut -2-.
4. Use the pole terminal puller 60 x 40 NR.99 to pull the wiper arm off the wiper linkage and remove the wiper arm.





Pulling off wiper arms

Installing wiper arm for rear window wiper system

1. Switch on ignition and move rear wiper motor to its end position by activating it once.
2. Switch off the ignition.
3. Fit wiper arm -3- and secure with the fastening nut -2-. => Tightening torque: 12 Nm (9 ftlb.)





Fitting rear window wiper fastening

Information

Before fitting the cap, check the retaining lugs of the cap for damage. The cap must be replaced in the event of damage or if you have any doubts about it.

4. Fit cover cap -1- and press in until it is felt to engage.