34352750 Removing and mounting transmission

WM 343527 Removing and mounting transmission

Tools





Technical values





Preliminary work

1. Remove engine-transmission unit. -> 100119 Removing and installing engine - section on "Removing" 100119 Removing and installing engine

Removing transmission

Removing accessories

1. Unscrew fastening nut of exterior shift.





Fastening nut

2. Pull off exterior shift using Schremm 48-2 puller 00000 from shifting shaft.





Pulling off the exterior shift

3. Unscrew fastening screw between clutch slave cylinder and transmission and remove clutch slave cylinder.





Clutch slave cylinder

4. Pull off electric connector for reversing light switch.





Reversing light switch

5. Remove mount for exhaust system from transmission.





Mount for exhaust system

Removing transmission

1. Unscrew fastening screws -1 to 8- and pull out transmission to the rear.





Fastening transmission to engine

Mounting transmission

Refitting transmission

Information

Before installing the transmission, clean splines of transmission input shaft and grease lightly, e.g. with Olista Longtime 3 EP.

1. Move transmission into position and screw in fastening screws -1 to 8-.





Fastening transmission to engine





Fitting accessories

1. Fit mount for exhaust system on transmission.





Mount for exhaust system





2. Push on electric connector for reverse gear switch.





Reversing light switch

Information

Before installing the clutch slave cylinder, grease the push rod with Kluberalfa in the area of the release-lever ball socket. Part No. 000.043.304.02 (50g tube).

3. Insert clutch slave cylinder in transmission opening and screw in fastening screw.





Clutch slave cylinder





4. Fit the external shift mechanism and tighten nut.





Fastening nut





Subsequent work

1. Install engine-transmission unit. -> 100119 Removing and installing engine - section on "Installing" 100119 Removing and installing engine