Removing and Installing Wing Flange Cover

Removing And Installing Wing Flange Cover

Removing wing flange cover

Removing cover for wing flange

1. Open front lid.
2. Loosen cover for wing flange -2- at the Velcro fasteners -3-.







3. Lift cover for wing flange up slightly -2-, release the locking tab at the side from below -arrow A- and pull it out of the cover for the lock support -1- ( -arrows B- ).

Installing wing flange cover

Installing cover for wing flange

INFORMATION: The Velcro fasteners must be removed and replaced when replacing the wing and cover for wing flange.

1. Check Velcro fasteners on wing and cover for wing flange and replace if necessary.
2. Insert cover for wing flange -2- sideways into the trim panel for the lock support -1- ( -arrows A- ).







3. Slide cover for wing flange -2- with the soft lip under the luggage compartment seal and press on Velcro fasteners -3-.
4. Lock cover for wing flange into place in plenum panel.







5. Insert locking lug for trim panel for lock support -1- into the wing at the side -2-.







6. Close front lid.

Additional assembly instructions for replacing Velcro fasteners

1. Remove protective paper on the underside, push locking lug into the cover for lock support and press cover down onto the wing flange.







2. Press Velcro fasteners on at the positions indicated.







3. Lift off cover and press Velcro fasteners securely onto the wing flange again using a suitable tool.