Removing and Installing Short Halfshaft Flange

WM 392519 Removing and installing short halfshaft flange





Preliminary work

Preliminary work
1. Raise the vehicle at the prescribed jacking points.
2. Remove right rear wheel.
3. Remove the underbody panel.

Removing short halfshaft flange

Removing short halfshaft flange

Note
Protect drive shafts against mechanical damage (e.g. with a rubber hose which has been cut open).

1. Remove drive shaft on transmission side. To do this, unscrew the six Allen screws joining the drive shaft and halfshaft flange.





2. Remove spacer ring.
3. Undo both upper control arms at the outside and remove screws.





4. Unscrew fastening screw for halfshaft flange. To do this, screw two drive shaft screws into the halfshaft flange for countering purposes and loosen fastening screw.





5. Press wheel carrier downwards and pull out halfshaft flange.

Installing short halfshaft flange

Installing short halfshaft flange
1. Push halfshaft flange into transmission.
2. Screw in fastening screw for halfshaft flange. To do this, screw two drive shaft screws into the halfshaft flange for countering purposes and tighten fastening screw.








3. Screw in and tighten fastening screws for upper control arms.








Note
Protect drive shafts against mechanical damage (e.g. with a rubber hose which has been cut open).

4. Fit drive shaft on transmission side. To do this, screw in the six Allen screws joining drive shaft and transmission flange and tighten screws.








Subsequent work

Subsequent work
1. Fit right rear wheel.
2. Check transmission oil level in the final drive and top up if necessary.
3. Fit the underbody panel.
4. Lower the vehicle.