Ignition Coil: Service and Repair

Removing And Installing Ignition Rod Module

Tools







Technical values







Preliminary work
1. Remove rear wheel.
Socket-wrench insert P300 should be used to avoid damaging the rims.
2. Remove rear silencer.
3. Remove upper part of heat shield.
3.1. Unscrew two M6 x 12 outer Torx screws (socket insert E10) and remove heat shield.

Removal

Removing ignition rod module

Component overview:






1. Disconnect cable plug -1- by pressing firmly on the locking lug and sliding the plug upwards.










1.1. Unscrew inner Torx screw (M6 x 16) -2- and pull out ignition rod module.

Installation

Installing ignition rod module
1. Connect ignition rod module.
1.1. Fit inner Torx screw (M6 x 16) -2- and tighten to the prescribed tightening torque.










1.2. Connect cable plug -1-. When doing so, make sure you hear it latching into place and check that it firmly seated by pushing it up.

Subsequent work
1. Install upper part of heat shield.
1.1. Fit heat shield and screw in and tighten two M6 x 12 outer Torx screws (socket insert E10).
- Tightening torque: 10 Nm (7.5 ftlb.)

2. Install rear silencer.
3. Mount rear wheel.
Socket-wrench insert P300 should be used to avoid damaging the rims.