Removing and Installing Servo Motor For Front Lid

Removing And Installing Servo Motor For Front Lid Release

Preliminary work

Preliminary work for servo motor for hood release

Remove cover for lock support. Refer to Removing and installing lock mount cover.

Remove left wheel housing liner. Refer to Removing and installing front wheel housing liner.

Removing servo motor for front lid release

Removing the servo motor for front lid release







1. Switch off ignition and remove ignition key.
2. Lay luggage compartment carpet in front in the direction of travel from left to right.
3. Release electric connector -A- and unplug it at the servo motor.







4. Bend up cover at the lock, pull bowden cable to the left and disengage at lock.







5. Pull the bowden cable for the lock actuator -B- and the emergency operation bowden cable -A- inward through the grommets.







6. Remove servo motor.

Installing servo motor for front lid release

Installing the servo motor for front lid release

1. Route the bowden cable for the lock actuator -B- and the emergency operation bowden cable -A- through the grommets.







2. Engage the bowden cable at the lock and bend down the cover.







3. Push electric plug onto the servo motor until it is felt to engage.
4. Insert the servo motor in the luggage compartment area and replace the carpet correctly.

Subsequent work

Subsequent work for servo motor for hood release

Install front left wheel housing liner. Refer to Removing and installing front wheel housing liner.

Install cover for lock mount. Refer to Removing and installing lock mount cover.