Overhaul

Disassembling And Assembling Rear Lid

Preliminary work

1. Remove rear spoiler. Refer to Removing and installing rear spoiler.
2. Remove rear lid. Refer to Removing and installing rear lid.
3. Remove spoiler drive. Refer to Removing and installing spoiler drive.
4. Remove wire harness for rear spoiler. Refer to Removing and installing wire harness for rear spoiler.
5. Remove upper part of rear lid lock. Refer to Removing and installing upper part of rear lid lock.
6. Remove rear logo. Refer to Replacing rear logo.

Disassembling rear lid

Removing adjusting element







1. Unscrew rubber buffer -1- and unclip collar -2-.







Removing rubber cover

1. Pull rubber cover -1- off the rear lid.







2. Loosen adhesive residue on the rear lid using a silicone remover and remove it.

Assembling rear lid

Fitting rubber cover

INFORMATION: Bonding surface must be clean and free of grease. Clean with cleaning solution if necessary.

1. Detach protective film and stick rubber cover -1- into the rear lid.







Installing adjusting element

1. Clip in collar -2- and screw in rubber buffer -1-.







Subsequent work

1. Install logo. Refer to Replacing rear logo.
2. Install upper part of rear lid lock. Refer to Removing and installing upper part of rear lid lock.
3. Install wire harness for rear spoiler. Refer to Removing and installing wire harness for rear spoiler.
4. Install spoiler drive. Refer to Removing and installing spoiler drive.
5. Install rear lid. Refer to Removing and installing rear lid.
6. Install rear spoiler. Refer to Removing and installing rear spoiler.