Removing and Installing Suction Fan For Backrest Surface

Removing And Installing Suction Fan For Backrest Surface

Preliminary work

1. Switch off ignition and remove ignition key.
2. Remove cover for suction fan and disconnect suction fan from the cover. Refer to Removing and installing cover for suction fan.

Removing suction fan for backrest surface







1. Turn suction fan for backrest surface clockwise -arrow A- until the suction fan for the backrest surface is released. Counter at the air duct -B- while doing this.







2. Remove suction fan for backrest surface from the air duct -arrow B-.

Installing suction fan for backrest surface

1. Check rubber mounting -1- for damage and replace it if necessary.







INFORMATION: Ensure that the suction fan is installed at the correct position.

2. Insert suction fan for backrest surface into the air duct -arrow A-, press it in and turn anti-clockwise until the suction fan for the backrest surface is fully locked in the air duct.







Subsequent work

1. Fit suction fan on the cover and install cover for suction fan. Refer to Removing and installing cover for suction fan.
2. Check that the suction fan is functioning correctly.