Removing and Installing Locking Mechanism For Rear Backrest

Removing And Installing Locking Mechanism For Rear Backrest

Technical values







Preliminary work

Remove rear backrest. Refer to Removing and installing rear backrest.

Removing locking mechanism for rear backrest

1. Press out control button -1- with a screwdriver.







2. Unscrew fastening screws -2- and remove collar -3-.
3. Unscrew fastening screws -1- and remove cover for lock -2-.







4. Remove protection washer -1- (-arrow A-).







5. Press out cover for backrest -2- at the sides with a screwdriver -arrows B-.
6. Fold padding -1- inwards -arrow A-.







7. Press reset spring -2- together -arrows B- and remove upwards.
8. Unclip cover -3-.
9. Unscrew fastening screws -4- and remove lock for backrest -5- by pulling it upwards -arrow C-.

Installing locking mechanism for rear backrest

1. Position lock for backrest -5- on the backrest frame -arrow A- and screw in the fastening screws -4-. Tightening torque: 12 Nm (9 ftlb.)±2 Nm (±1.5)







2. Clip in cover -3-.
3. Press in reset spring -2- until it engages -arrows B- and check lever function.
4. Press connection for backrest cover -2- sideways into the backrest frame with a plastic wedge -arrows A-.







5. Press in protection washer -1- (-arrow A-).
6. Position cover for lock -2- and screw in the fastening screws -1-.







7. Place collar -3- in position and screw in the fastening screws -1-.







8. Press in control button -2-.

Subsequent work

Install rear backrest. Refer to Removing and installing rear backrest.