Removing and Installing Console For Telephone

Removing and installing console for telephone

Technical values












Removing console for telephone













1. Release interface box -Arrow a- and pull it down and off.
2. Unscrew the fastening screws for the interface box holder from the upper part -E-.







3. Unscrew fastening screw -4- from upper part -E-, raise upper part and leave it hanging forwards.







4. Unscrew fastening screw -3- from inner part-outer part -A, D- and pull side panel -A- to the left and leave it hanging out.







5. Undo the three fastening screws -2- from the clamp -B- and remove clamp.
6. Remove the outer part -D- together with cable duct -C- from the holder on the centre console.







7. Pull the VDA interface and antenna leads under the centre console -G- and disconnect them, then remove the upper part with cradle.

Installing console for telephone

INFORMATION: Lay the leads so that they are not pinched.







1. Fit the upper part -E- loosely to the outer part -D- and lay the VDA interface lead and antenna lead in the outer part -D-.
2. Engage the cable duct -C- in the outer part -D-.







3. Lift the assembled components -C, D, E- onto the centre console holder, engage the cable duct at the lower edge of the centre console, and push the components -C, D, E- onto the centre console holder.
4. Place the clamp on the outer part and secure with the three fastening screws -2-. - Tightening torque: 1.5 ftlb.







5. Engage the inner part -A- with the outer part -D-, then clip into the outer part and secure with the fastening screw -3-. - Tightening torque: 0.5 ftlb.







6. Engage the upper part -E- in das inner-outer part -A, D- and secure with the fastening screw -4-. - Tightening torque: 0.5 ftlb.







7. Drill hole in cover and insert fastening screw -1- for the interface box holder in the upper part -E-. - Tightening torque: 0.5 ftlb.







8. Push the interface box onto the cradle from below until the interface box engages.







9. Connect wiring for the VDA interface and antenna leads -G- - Centre console -F- - Seat
10. Raise the centre console and push the wiring under it.
11. Move the seat to the position required by the customer.