Removal and Replacement

Bearings for rear axle








Tools and materials
Tool overview for chassis subframe bearings assembly fixture T10301





Tool overview for chassis subframe bearings

-A- - Hydraulic cylinder VAS 6178 (The hydraulic cylinder is used together with the foot pump VAS 6179 and the pressure gauge with connecting cable VAS 617911 -B-.)
-1- - Threaded rod (Inserted into the tubular piston cylinder -A
-2- - Threaded nut (Screwed onto the threaded rod -1-.)
-3- - Pipe (For pressing out the chassis subframe bearings.)
-4- - Ring (For pressing out the chassis subframe bearings.)
-5- - Press-out plate (For pressing out the chassis subframe bearings.)
-6- - Pressure piece (For pressing in the chassis subframe bearings.)
-7- - Press-in plate (For pressing in the chassis subframe bearings.)
-8- - Ring (For pressing out the chassis subframe bearings.)
-9- - Spacer sleeve (For pressing out the chassis subframe bearings together with pipe -3-.)
-10- - Pressure piece (For pressing in the chassis subframe bearings.)
-11- - Spacer sleeve (For pressing in the chassis subframe bearings.)

Porsche supplement set T10301/20





Assembly fixture T10301/20

-2- - Threaded nut (Screwed onto the threaded rod -1-.)
-12- - Press-out ring (For pressing out the chassis subframe bearings.)
-13- - Pressure piece (For pressing in the chassis subframe bearings.)
-14- - Bush (For pressing out the chassis subframe bearings.)

Counter support, 0 - 40 mm NR.106

Internal puller NR.108

Separating device, 12 - 115 mm [diameter] NR.111

Subsequent work
1. Fit rear muffler.
2. For front RA chassis subframe bearings: Fit stone guard.
3. Check running gear and adjust it if necessary.