Removing and Installing Wire Harness For Starter Battery

Removing and installing wire harness for starter battery

Technical values







Preliminary work
1. The battery ground strap must be disconnected before starting disassembly work.
2. Remove front left covers (engine compartment).

Installing wire harness for starter battery

Installing external power connection







1. Connect external power connection -1- to the B+ line -2- ( -arrow- ) until the locking lugs -arrows- of the external power connection -1- engage securely.







2. Position external power connection -2- on the holder -arrow- and secure with the fastening screw -1-. - Tightening torque: 10 Nm (7.5 ftlb.)±1 Nm (±0.5 ftlb.)







3. Insert connecting piece for B+ lines -1- and press it in -arrow- until the locking lugs -arrows- engage securely.
4. Insert B+ lines.
4.1. Insert B+ lines -3, 4 and 5-.
4.2. Tighten fastening nut -2- for B+ lines. - Tightening torque: 10 Nm (7.5 ftlb.)±1 Nm (±0.5 ftlb.)







4.3. Close cap -1- until the cap -1- is felt to engage.







5. Tighten fastening nut -2- for B+ line and close cap -1- until the cap -1- is felt to engage. - Tightening torque: 20 Nm (15 ftlb.)±1 Nm (±0.5 ftlb.)

Subsequent work
1. Install front left covers (engine compartment).
2. Connect battery ground strap and carry out work instructions after disconnecting the battery.