Removing And Installing Tiptronic Wire Harness

Removing And Installing Tiptronic Wire Harness

Preliminary work
1. Remove engine guard.

Removing Tiptronic wire harness















1. Unscrew fastening screws -1- and remove the heat shield -Arrow-.







2. Release the connector -Arrow A- and pull it off -Arrow B-.
3. Remove the socket from the bracket -Arrow C-.







4. Open the clip -Arrow A- and remove the line -Arrow B-.
5. Release the connector using an angled piece of wire (approx. 2 mm in diameter) -Arrow C- and push it down off the multi-functional switch -Arrow D-.

Installing Tiptronic wire harness







1. Push the connector onto the multi-functional switch -Arrow A- until the locking lug -B- is felt to engage.
2. Insert the line into the clip -Arrow C- and close the clip -Arrow D-.







3. Insert the socket into the holder -Arrow A-.
4. Push in the connector -Arrow B- until the locking lug is felt to engage -C-.







5. Place heat shield in installation position -Arrow- and secure with fastening screws -1-.

Subsequent work
1. Fit engine guard.