519319 Removing and Installing Centre Cover

WM 519319 Removing and installing centre cover

Technical values






Removing centre cover





Installation position of centre cover

1. Unscrew fastening screw -1- and remove rear lifting platform holder -2- in a downward direction -arrow-.





Removing rear lifting platform holder

2. Unclip cover -1- at the centre cover -2- in a downward direction -arrow A- and pull it out -arrow B-.





Removing cover

3. Unscrew fastening screws -1- and remove centre cover -2- in the rear area by pulling it down from the body -arrow A-.





Removing centre cover

4. Pull out centre cover -2- in the front area under the wheel housing liner -3- ( -arrow B- ).

Installing centre cover





Installation position of centre cover

1. Position centre cover -2- on the body -arrows A- , guide it in at the front under the wheel housing liner -3- and slide it forward -arrow B-.





Install centre cover

2. Tighten fastening screws -1-. => Tightening torque: 2 Nm (1.5 ftlb.)
3. Slide cover -1- into the centre cover -2- ( -arrow A- ) and clip it in by pushing it upwards -arrow B-.





Installing cover

4. Position rear lifting platform holder -2- on the body -arrow- and secure with the fastening screw -1-. => Tightening torque: 9 Nm (6.5 ftlb.)+/-0.5 Nm (+/-0.5 ftlb.)





Installing rear lifting platform holder