Sunroof / Moonroof Module: Service and Repair

WM 606519 Removing and installing control unit for roof assembly (panoramic roof)

Technical values





Preliminary work

1. Removing headliner. -> 708419 Removing and installing headliner - "Removing" section 708419 Removing and installing roof lining
2. Remove ignition key.

Removing control unit for roof assembly (panoramic roof)





Overview of control unit for roof assembly (panoramic roof)

1. Release the connectors -Arrows A- and pull them off -Arrows B-.





Pulling off connectors and removing control unit

2. Unscrew fastening screws -1- and remove control unit.





Pulling off connectors and removing control unit

Installing control unit for roof assembly (panoramic roof)

Information

- After installation of the control unit, the limit stops for the motors must be re-initialised.

1. Position control unit in installation position -Arrows A- and secure with the fastening screws -1-. => Tightening torque: 3 ftlb.





Installing and securing control unit and inserting connector

2. Push in the connectors -arrows B- until the locking tabs -C- are felt to engage.





Installing and securing control unit and inserting connector

3. Initialise limit stop of both motors. -> 60 Closing roof assembly (panoramic roof) with emergency operating mechanism and initialising limit switch

Subsequent work

1. Install headliner. -> 708419 Removing and installing headliner - "Installing" section 708419 Removing and installing roof lining