Camshaft Position Sensor: Service and Repair

WM 283919 Removing and installing hall senders (camshafts) on DFI engines

Technical values





Information

Component changes for model year 2009 as of October 2008

Information

Always read the information concerning modified tightening specifications and component changes relating to repairs provided for specific engine numbers in the Information section -> 1001IN IMPORTANT component changes for V8 engines as of October 2008 1001IN IMPORTANT component changes for V8 engines as of October 2008.

Preliminary work

1. Remove design cover on bar ignition modules. -> 108319 Removing and installing engine cover (design cover) on DFI engines - section on "Removing" 108319 Removing and installing engine cover (design cover) on DFI engines

Removing hall sender

Information

- Replace all gaskets and O-rings.

- Use the lubricant Kluber Syntheso Glep (Part No. 000.043.204.68).

1. Disconnect connector on hall sender. To do so, push the button and remove.





Valve cover seals, cylinders 1 to 4









Valve cover seals, cylinders 5 to 8





2. Loosen fastening screw on hall sender and pull hall sender out carefully.

Installing hall senders (as of October 2008)

1. Fit the hall sender into the valve cover and tighten the fastening screw.





Valve cover seals, cylinders 1 to 4









Valve cover seals, cylinders 5 to 8





2. Slide on cable plug. The connector must engage audibly.

Subsequent work

1. Install design cover. -> 108319 Removing and installing engine cover (design cover) on DFI engines - section on "Installing" 108319 Removing and installing engine cover (design cover) on DFI engines