Hazard Warning Switch: Service and Repair

WM 944719 Removing and installing hazard warning light switch

Preliminary work

1. Remove PCM. -> 911019 Removing and installing display and operator control unit (PCM) - section on "Removing" Service and Repair
2. Remove radio. -> 912419 Removing and installing car radio - section on "Removing" Service and Repair

Removing hazard warning light switch





Overview of hazard warning light switch

1. Switch off ignition and remove ignition key.
2. Reach into the opening left by the removed PCM or radio, press the two retaining clips -arrows 1- together and remove the switch -arrow 2- to the front.





Removing hazard warning light switch

3. Press locking element of plug connection and remove connector.





Removing connector

Installing hazard warning light switch

1. Insert connector through the opening in the retaining bracket and push connector onto the hazard warning light switch until it is felt to engage.





Plugging in connector

Information

- The retaining clips must engage.

2. Slide the switch into the retaining bracket until it clicks into place.





Installing hazard warning light switch

Subsequent work

1. Install PCM. -> 911019 Removing and installing display and operator control unit (PCM) - section on "Installing" Service and Repair
2. Install radio. -> 912419 Removing and installing car radio - section on "Installing" Service and Repair