927719 Removing and Installing Hose For Headlight Washer System

WM 927719 Removing and installing hose for headlight washer system

Preliminary work

Removing front apron. -> 631519 Removing and installing front apron - "Removing" section

Removing hose for headlight washer system





Overview of hose for headlight washing system

1. Unclip the high-pressure hose -arrows A-.





Unclipping the high-pressure hose

2. Remove retaining clip -arrow B- and pull off the hose on both spray jets -arrow C-.
3. Cut through the tie-wraps -arrow A- and remove the hose on the right side -arrow B-.





Tie-wrap to hose fastening

Installing hose for headlight washer system

1. Slide in hose on the right side -arrow A- and position it along the electrical wiring harness.





Routing the hose

2. Push the hose onto the spray jets -arrow B-.
3. Press on the retaining clip -arrow C- until it locks in place.





Information

- Before tightening with tie-wraps, make sure hose does not chafe on locking tabs of parking aid -B-.

4. Tighten hose with tie-wraps -arrow A- to the electrical wiring harness.





Fastening the hose

5. Press hose in until it is felt to click into place in the clips -arrows-.





Clipping in the hose

Subsequent work

Installing front apron. -> 631519 Removing and installing front apron - section on "installing"