Pyrotechnical Cutoff Relay

Removing and installing cutoff relay

Technical values







Installing cutoff relay

Installing pyrotechnical cutoff relay

INFORMATION: Use new nuts.







1. Position the cutoff relay -2- in the power distributor. Screw on the two fastening nuts -3- on the cutoff relay. - Tightening torque: 20 Nm (15 ftlb.)
2. Connect electric connector -1- to cutoff relay and lock it -arrow a-.







3. Slide cover of power distributor from front to back -arrow A- and press it on -arrow B- until the latch locks into place.

INFORMATION: Only for vehicles with auxiliary battery







4. Attach the line for the additional battery to the threaded bolt -arrow A- and secure with the fastening nut -3-. - Tightening torque: 20 Nm (15 ftlb.)
5. Close the cover -arrow B- until the locking lugs -arrows C- engage securely.







1. Fold carpeted floor forward -arrow A-, place battery ground strap on the body -arrow B- and secure with the fastening nut -1-. - Tightening torque: 20 Nm (15 ftlb.)







2. Move the seat in its folded position towards the rear -arrow A- and then tip it forward -arrow B-.
3. Tighten fastening screws -1-. - Tightening torque: 45 Nm (33 ftlb.)







4. Clip in the right and left carpet cover -arrows- until they engage securely.







5. Clip in the front seat trim at the front seat frame and at the side trim panel -arrow A-.
6. Press the front seat trim down -arrow B- until the locking lugs engage securely on the seat frame.