Removing and Installing Cover For Rear Underbody

Removing And Installing Cover For Rear Underbody

Technical values







Preliminary work

Lift the vehicle. Refer to Lifting the vehicle

Removing cover for rear underbody







INFORMATION: Fastening nuts cannot be used again following removal.

1. Unscrew fastening screws -1- and fastening nuts -2, 4-.







2. Pull cover for rear underbody -3- out of the overlap.

Removing support for underbody cover







1. Unscrew fastening nut -1- and remove support -2-.







2. Check support -2- and fastening nut -3- and replace if necessary.

Installing cover for rear underbody

Installing support for underbody cover







1. Position support -2- for underbody cover and tighten with the fastening nut -1-. Tightening torque: 7 ftlb. ±0.5 ftlb.







Installing underbody cover







INFORMATION: When pushing in the underbody cover, make sure the overlap is correct.

1. Insert cover for rear underbody -3-.







2. Tighten fastening screws -1-. Tightening torque: Final tightening: 1.5 ftlb. ±0.5 ftlb.
3. Tighten fastening nuts -2-. Tightening torque: Final tightening: 1 ftlb. ±0.5 ftlb.
4. Tighten fastening nuts -4-. Tightening torque: Final tightening: 3.5 ftlb. ±0.5 ftlb.

Subsequent work

Lower the vehicle. Refer to Lifting the vehicle.